Perfboard is a base for prototyping circuit boards. It has holes pre-drilled at set intervals across a grid, usually a square grid of 2.5mm (0.1") spacing. Perfboard can be used for wire wrap prototypes and for solder prototypes. Copper or another metal can be plated onto the substrate in pre-arranged patterns. Discrete components are attached to the prototype board such as resistors, capacitors, and integrated circuits. The substrate is typically made of fiberglass or synthetic resin bonded paper.

To use Perfboard you would solder on the bottom of the board and scrape away the copper where you do not want connections. (see photos below)

Top of a copper clad Perfboard with solder pads for each hole.
Bottom of a copper clad Perfboard with a ground plane


See also

 This technology-related article is a stub. You can help Wikipedia by expanding it.
Retrieved from "http://en.wikipedia.org/wiki/Perfboard"

No comments have been added.



Your name:

City:

Country:

Your comments:

Security check *
(Please enter the number into adjoining box)